I added the screen shot of the Plug-In Pin Connector settings The drawback of this method is that I have to keep the reaper running all the time.īut I wouldn't mind because I always have a reaper running. So I don't have to think about the audio interface or audio driver signal flow. The PC sound signal enters the DAW by the new back door called ReaRoute. The advantage of this method is that ARC's System-wide process is possible with Reaper running with the same audio driver as usual. Therefore, once set, no further operation is required. This setting is saved and can be automatically executed when the PC starts. It is necessary to set the device to "ReaRoute ASIO" using the included ASIO BRIDGE software. This allows you to apply ReaInsert and ARC to the entire sound played by Reaper regardless of the project.Īt the end, VB-Audio Hi-Fi Cable can route PC sounds to ASIO. This is a plugin that allows you to make sound doorways inside a plugin rather than a track.Īnd, Reaper has a function called Monitorring FX, which is common to all projects, and can apply effects to monitors. Reaper also has a routing plugin called ReaInsert. This allows you to have input / output channels from outside the audio interface. Reaper has an audio routing function called ReaRoute. PC Sound (iTunes, Browser etc.) -> VB-Audio Hi-Fi Cable -> ReaRoute -> ReaInsert -> MonitoringFX -> ARC Once prepared, all you need to do ARC system-wide process is just run Reaper only. VB-Audio Hi-Fi Cable (Not an ordinary one.It must be "Hi-Fi" one.) I have found a convenient way for Reaper users to use ARC system-wide.
0 Comments
Leave a Reply. |